DodgeIntrepid.Net Forums banner

2.7l Leaking Oil

638 views 3 replies 3 participants last post by  MegaTrep 
#1 ·
My 2.7l is leaking oil. It is coming from the two horizontal 6mm bolts at the front of the pan. I think that it is the one on the driver's side. I had the pan off before it started to leak. I just bought a new gasket for it but haven't installed it yet. Does anyone know how I can get this damn thing to stop marking its territory on the driveway?
Thanks in advance for the replies.
 
#2 ·
If its in the area I think it is, those bolts connect the pan to the timing cover. clean that area off and run a bead of RTV in that groove between the pan and the timing cover.
 
#3 ·
It sounds like it is at the front where the block, timing cover and pan all meet.. When you replace the gasket this area needs a good bead of RTV sealant.. If you loosen a few of the front pan bolts and the horizontal bolt you should be able to inject a bead of sealant into the area and tighten back up to seal the current leak...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top