I am making up a cable to send to someone to install with a device on their 1st gen. Intrepid. Trouble is, I need to know where a certain ground attachment point is, and I don't have a 1st gen. car to look at.
On the 2nd gens., there are two 6 mm ground studs located just to the right of the gas pedal on the left side of the console hump - right under the carpet. Normally that's where I attach the ground wire of this cable (ring terminal on the end of the wire, sized to fit the 6 mm ground stud).
2nd gen - looking at drivers side of console, gas pedal on left of photo, ground studs hidden under carpet (see next photo):
Same view with carpet pulled back slightly to reveal ground studs under the air bag module:
Ground locations figure from 1st gen. FSM is below. Is the radio/ATC/air bag module ground point (arrow from upper red circle) exactly the same as on the 2nd gen. as shown in the two photos (i.e., exact same location, 6 mm stud welded to floor)? If not, where exactly is it located, and what does it look like (i.e., how do wires attach)? If it is difficult to get to, what can you tell me (exact location, ease of access, how wires attach) about the junction block/door locks/power windows ground that I've also circled at the bottom of the figure?
Thanks for any help!