Join Date: Mar 2005
Location: Tiny Pebble, AR
You'll need a trip to the dealer to program at least one remote fob. After that you can program additional remote fobs yourself.
STANDARD PROCEDURE - TRANSMITTER
The Remote Keyless Entry (RKE) Transmitter(s)
can be programmed with the use of the DRB IIIt
scan tool, or by the customer.
PROGRAMMING TRANSMITTER WITH THE DRB
IIIT SCAN TOOL
For procedures on programming the transmitter(s)
with the DRB IIIt scan tool, refer to the proper Body
Diagnostic Procedures Manual.
PROGRAMMING BY CUSTOMER
For a customer to be able to program RKE transmitters
themselves, at least one RKE transmitter
must be programmed already. This procedure is to
add additional transmitters. If all transmitters are
lost, the DRB IIIt scan tool must be used to program
the new transmitter(s).
Transmitter programming by the customer is done
by continually pressing the unlock button, on a programmed
fob, for a minimum of 4 seconds to a maximum
of 10 seconds with the ignition switch ON.
Within the 4-10 second range, the panic button is
depressed. Both buttons are then released.
The BCM will chime. Them press any button on
each fob to be programmed. The BCM will chime as
each fob is learned. To exit program mode, turn off
ignition or wait 32 seconds. The BCM will chime
JJI=Just Junk It, LLC!
Member of the Sold SRT-8 Magnums of DI.net Club!
Perky Jerky for Everyone!!
Crazy Rons House of Mega Deals
Member of the CAN Bus Bitches Club!