rear main seal
Hello treppers: I have an update on my 3.2 rebuild redo. Purchased a reground crank kit w/bearings, and had to get one new (refurbed) con rod, so I can now continue with redoing the bottom end after I have ev'rything cleaned up. I have a question, which I posted previously but got no response, so here goes again: I bought one of the rear main seal housings under the new part number, and I noticed that it doesn't have the rubber/nitride strip to seal against the oil pan like the original housing did. Any suggestions on how to seal this so I don't have oil leaking out the back of the oil pan?