The bottom rear vent on the back of my console is broken...one of the plastic pieces broke off and it really bothers me. I would like to get a new console. Also, the white letters PRND3L and the circle surrounding them are starting to fade. Hopefully I can find one at a junkyard for cheap. Does anyone know how to take out and install the console? Also, how much one would one cost from a junkyard? Thanks.
Console
1 - 4 of 4 Posts
Joined
·
462 Posts
CONSOLE
Probably cost about $60-70 at a junk yard
Probably cost about $60-70 at a junk yard
console
I'm assuming you have to open the console (and there's probably screws at the bottom.)
Also, there will most likely be some at the front where it meets the dash, you'll probably have to take off the dash plate to get to them.
Whenever you do it, take some pics, it would make good reference for others on the site. :wink:
I'm assuming you have to open the console (and there's probably screws at the bottom.)
Also, there will most likely be some at the front where it meets the dash, you'll probably have to take off the dash plate to get to them.
Whenever you do it, take some pics, it would make good reference for others on the site. :wink:
Joined
·
8,099 Posts
I did it on my 2nd gen. It's a huge ass piece that does go into the dash under the head unit. The first time was a *****, but next time i have to do it, it should be easier 
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Anyone Ever Replace the Steering Coupler/Intermediate Shaft on their First Gen?
General Discussion (First Generation)After lurking through various old threads on the forum, most steering problems have been resolved by changing inner tie-rod bushings, tension strut bushings, lower control arms, and the steering rack itself. But has there ever been an instance where the coupler/intermediate shaft was the culprit...- 0
- 68
-
Got an Email from Glen Rissberger Today
General Discussion (First Generation)In my previous thread on Lateral Link Compatibility, EagleEsi made reference to a "Super uber rare sway bar," which was designed by Quickor. Naturally, I had to research this and so I contacted Glen Rissberger back in December. He noted that it had been over a decade since he had produced this...- 1
- 176
-
Help 3.5 lhs wont idle
General Discussion (First Generation)Help please I have a 3.5 lhs 95. The battery was dead from lights being left on. It was running great with only 130k I jumped it now it won't idle but the engine light is not on and when I turn the keys off and on it's not giving me any codes. What should I do first thanks- 8
- 559
-
Ed450x · updated
-
New 97, couple mechanical problems
General Discussion (First Generation)Hey everyone. I just picked up a 97 Chrysler Intrepid (Canadian spec) and the brakes are soft. Pads/discs are new but the brake fluid started leaking on the front passenger side after I drove it home for the first time today. Took it up the street to an indie shop and they tightened the brake...- 0
- 398
-
Scolirk · updated
-
Friction Modifier???
General Discussion (First Generation)When changing the diff fluid, does It require a friction modifier? I remembered having to use it in my 97 Ram, but was unsure about the Concorde. Also what is everyone's thoughts on using Lucas in the diff?- 2
- 312
-
Lexacocca · updated
Join now to ask and comment!