DodgeIntrepid.Net Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
204 Posts
Discussion Starter #1
My dad just picked a 2001 2.7l sebring sedan lxi for really cheap since it has spun 2 rod bearings. There is no sludge in the motor so he is just going to rebuild the whole thing and replace water pump, timing, gaskets etc... We are going to go with a crankshaft kit but are in need of 2 connecting rods(preferably with pistons already attached). They should be the same part numbers as the intrepid 2.7l but my dad will check that out sometime this week. So if anyone has any spare GOOD connecting rods from a junk motor then let me know!! Not looking to spend much either. Thanks
 
1 - 2 of 2 Posts
Top