DodgeIntrepid.Net Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter · #1 ·
hey i was reading on allpar and found out that the new 4.0 v6 that is coming out is an enlarged version of the second gen 3.5. if the block casting is the same, could that crank fit in a 1g block? if so, the 4.0 has the same bore diameter, which makes me think that the block is the same as the 3.5, and the crank has a 3.58 inch stroke instead of 3.19. if this fit into our blocks, we could increase our displacement half a liter with factory parts. that would give a nice torque increase, and still rev like a 3.5! that would be amazing if done right. if this will not work, will someone smash my dream? :fun_84: lol
Later, David
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top