DodgeIntrepid.Net Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
My camshaft position sensornmeeds to be replaced isnit easy and location and what tools do i need
 

·
Premium Member
Joined
·
16,740 Posts
Year and engine...
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
2000 3.2 liter i have to take off whole intake manifold just to put the sensor in up front which would take about 3 minutes just for sensor replacement
 

·
Woober Goobers!
Joined
·
50,122 Posts
Some people have loosened the bolts for the upper Intake and tilted it to get enough access to the CPS. Many others recommend removing the upper Intake completely and replacing the gasket if necessary.
 

·
Registered
Joined
·
1,927 Posts
The last time I did one, I just loosened all of the the bolts and screws holding the upper intake in place; the seven or eight down the center, the three across the front and the two at the back left and right,
That givea you enough play to lift it just enough to get the little bugger out of there.
 
1 - 6 of 6 Posts
Top